SHOP THIS PRODUCT

This Radiolink RC4GS is a better and is a much more refined version of the RG3S and RG4G. This new RC4GS radio system is a great transmitter for all types of driving environments as it has a much faster response time and better driving feel. With loads of different settings allowing you to fine tune your car even more accurate so it drives true and to its maximum performance. With a digital computing system to set up all your trim settings you know that every time you turn on your car and transmitter everything is where it should be. With analog transmitters out there on the market that have little turning knobs to adjust trim setups, they can easily be knocked and then your car doesn’t drive straight anymore. You will not have this problem with this transmitter.   

 The RC4GS uses a STM32F103RB transmitter chip which is a much faster computing chip than the RC3S and RC4G which uses a N572F072 computing chip. Both the RC4GS transmitter and receiver uses an industrial chip to ensure superior anti-sparks interference making sure multiple players can operate their car at the same time without interfering with each other. Also a great feature with this new RC4GS transmitter and receiver system is that it has a built in gyro system. The gyro system can also be adjusted through the transmitter making it easy to setup to how aggressive you want the gyro to operate. Gyro systems are a great help to prevent you from spinning out.

The R4F and R4FG receivers also support an HV servo as these receivers can support up to 10 volts and has a ground range of up to 400 meters. These two receivers are also compatible with the following transmitters RC3S, RC4Gand T8FB.  

The RC4GS also features a 4 channel mixing program which allows you to mix every two channels as you wish. The built in adjustable ABS function helps you from locking up under heavy braking this aides going round corners without losing control. An anti-polarity protection has also been built in for safety measure just in case you accidently revers the polarity when plugging in the battery. This helps prevent the battery from damaging any of the firmware in the transmitter. To operate the transmitter you can use 4pcs AA batteries or 2S-4S LiPo battery with a universal JST connector. The firmware is easily upgradable as the RC4GS now has a USB connecting port built in so you can always have the most advance system and up to date program.  Failsafe can be set up from channel 1 to 4 to suite your needs.

For more information on RadioLink click here.