SPECIFICATIONS:

• Six port (two LEDs each group):head light, fog light, left & right turning light, backup light, brake light
• Two extended port(J7/J8):can DIY head light/brake light/width light
• Six flash mode: Burst flash mode, breathing lights mode, cruise lights mode , always on mode, related mode, neon mode
• Physical switching design, easy to installation and use.
• Wireless control mode & manual mode
• Scale lights unit makes your truck most likely the real.
• Material: Plastic

What’s included:

• Headlight:φ5mm LED*2PCS   white
• Fog light:φ3mm LED*2PCS  Warm-white light
• Left/right turning light:φ3mm LED*4PCS yellow
• Backup light:φ3mm*2PCS  white
• Brake light:φ5mm*2PCS  red
• Nylon Tie *6PCS;
• Clip *6PCS;
• Glue pad *1PCS;
• Manual *1PSC
• Control unit*1pcs
• Accessory pack

Installation: 

• Connect one with CH1 ST in the receiver
• Connect blue-tag wire with one port of the CH1 Y-wire
• Connect servo with the other port of the CH1 Y-wire
• Connect the other Y-wire with CH2 TH in the receiver
• Connect ESC with one port of CH2 TH Y-wire
• Connect red-tag to the other port of CH2 TH Y-wire

Testing

• If one turning light always flashes, please adjust receiver turning set-up channel till the light off.
• Left-turning (J1) ?J1 light flashing if not, please push DIP switch NO.1 to the opposite side.
• Head light/fog light (J2/J3) ?these two light should be high brightness when truck move forward; if not please push DIP switch NO.2 to the opposite side.
• J7:when DIP switch NO.3 in OFF side,J7=J2,which means you can DIY another head light into head light to make the head light brighter; when DIP switch NO.3 in ON side, J7 light will be always on ,then you can add extra light to act as width light
• J8:when DIP switch NO.4 in OFF side,J8=J6,which means you can DIY another brake light into brake light to make brake light brighter; when DIP switch NO.4 in ON side, J8 light will be always on ,then you can add extra light to act as width light