ATees Home Blog Accessories

Killerbody Smoky Exhaust Pipe With LED


SHOP THIS PRODUCT

After we upgraded our cars with the famous ESS-ONE engine sound system, it would be perfect if the car now can also emit smoke like any full size car. With the Killerbody smoky exhaust pipe with LED unit, here are all you need to do before you have a whole new realistic racing experience:

Use the pointed mouth of oil bottle to align with the oil filler hole, and fill up about 1 ml oil. Don't let the oil leak from the gas orifice when filling up oil, because too much oil will slow down the fuming speed. Use the rubber plug to stuff up the oil filler hole after filling up oil. Find a proper position to place the smoky exhaust pipe to secure the position. Insert the balance plug of the 7.4V battery. Then insert the remote control signal line and at this time, the smoky exhaust pipe gives out red light twice. Self-inspection is completed and it is working properly. Operate the remote control and push the throttle then you will see smoke coming out. If the smoke becomes less and less, you should fill up oil ASAP or just turn it off to prevent damage from overheating. Also, don't forget to disconnect the battery after using. If the product has flame output, gas output but no smoke output, please contact asiatees.com right away!

Specs:

  • Input power: 7.4V, max 1.3A
  • Control signal input: front and back remote signal input (including 5V power supply)
  • Battery low voltage protection: if the battery voltage is below 6.0V, the smoky exhaust pope will give out a short and a long flame signal and stop to give out smoke
  • Oil shortage overheating protection: when the oil is insufficient, the smoke will be thin; when the smoky exhaust pipe is overheating, the circuit will stop working and the smoky exhaust pipe will stop fuming. At the same time, the smoky exhaust pipe will give out slow-flashing flame signal until the temperature drops
  • Flame simulation: if the accelerator is larger, the flame flashing frequency is higher; when the generator is at idle, the flame flickering frequency is slow
  • Smoke simulation: if the accelerator is larger, there is smoke giving out; when in idle mode, only a little smoke is generated
  • It lasts 20 to 30 minutes when filling up the tank
Include:
  • Electric smoky exhaust pipe 1 set
  • Power connecting wire 1 pcs
  • Y connecting wire 2 pcs
  • Instruction sheet
Want to check out all the cool stuff from Killerbody this month? Visit our Killerbody Online Store.


SHOP THIS PRODUCT


BySharon Lan

Tags :Killerbody, smoky pipe, smoky exhaust pipe

Share:http://asiate.es/read?l=86FRDM35Z_3


comments powered by Disqus

Back To Top