SHOP THIS PRODUCT

SE2205 2300KV Motor

The new DYS SE2205 2300KV motors are some of the newest motors on the market. This new motor features a 5mm/4mm holloy shaft, that is held in place by a screw and retaining ring instead of the common C-clip. The standard 1.5mm hex head M2 screw provides an easy solution for retention and virtually non-existent vertical play. The hollow shaft design is also more resistant to bending. In no ways is this new or innovative, but it's been implemented extremely well. Their motor winding wires are using a thicker gauge than a lot of the current crop of motors. Weighing in at 32g each motor, they aren't incredibly light, but it's pretty standard! Here's the table of their expected thrust.

XM30A ESC

DYS's new XM30A ESCs are designed specifically for high KV motor applications. The small size of these ESCs plus their integrated solder pads provides an easier and cleaner installation process, especially when matched with their SE2205 2300KV motors. Here are some the specifications to expect out of this ESC!

Specifications:

• Input Voltage: 3-6S LiPo
• BEC: NO
• Size (mm): 38L x 16.5W x 6H
• Type: BLHeli Bootloader & Firmware
• Weight: 9.26G
• Built-in capacitor

Features:

• XM Series ESC is the upgraded version of the SN series with advanced processor, a basic frequency up to 50MHz, and faster overall processing capacity to better support high KV motors
• Designed for quick multirotor throttle response
• Twisted pair cable is used to deliver throttle signal, reducing signal crosstalk while further stabilizing copper wire transmission
• New miniaturization and ultra-low resistance MOSFET, powerful flow resistance, and professional MOS Drive chips improve efficiency
• Newly designed PCB board improves impact resistance.
• Sub-miniaturization design reduces weight while still providing a high performance filtering capacitor
• Refresh rate of throttle signal up to 500Hz, compatible with all modern flight controllers, including the Naze32 Rev6 and SP Racing F3
• Ultra-high speed Oneshot125 with 3000Hz Referesh Rate provides quick, smooth throttle response
• Fully programmable via USB port, with two-way and 3D modes for high speed racing and acrobatics

If you're interested, click the Shop Now button below to find them, along with all of our DYS products!